Uplander AWD V6-3.5L VIN 8 (2005)
1. Install the tie rod.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the tie rod nut.
^
Tighten the tie rod nut to 80 Nm (59 ft. lbs.).
3. Install the tie rod bolt.
^
Tighten the tie rod bolt to 85 Nm (63 ft. lbs.).
4. Install the tire and wheel assembly.
5. Adjust the rear toe angle.
6. Lower the vehicle.
Specifications
Rear Axle Tie Rod Bolt ........................................................................................................................................................................... 125 Nm (92 ft. lbs.)
Tie Rod Nut ............................................................................................................................................................................................... 80 Nm (59 ft. lbs.)
Tie Rod Bolt .............................................................................................................................................................................................. 85 Nm (63 ft. lbs.)
Tie Rod End
Rack and Pinion Outer Tie Rod End Replacement
^
Tools Required
-
J 24319-B Steering Linkage and Tie Rod Puller
Removal Procedure