Uplander AWD V6-3.5L VIN 8 (2005)
1. Install the ball stud to the lower control arm.
2. Install the NEW ball stud bolts facing down, away from the ball stud.
Notice: Refer to Fastener Notice in Service Precautions.
Important: This is a prevailing torque type fastener. This fastener may be reused ONLY if:
^
The fastener and its counterpart are clean and free from rust
^
The fastener develops 2 Nm (18 inch lbs.) of torque/drag against its counterpart prior to the fastener seating. If the fastener does not meet
these criteria, REPLACE the fastener.
3. Install the NEW ball stud nuts.
^
Tighten the NEW ball stud nuts to 68 Nm (50 ft. lbs.).
4. Install the lower control arm.
