Uplander AWD V6-3.5L VIN 8 (2005)
the frame.
Notice: Refer toFastener Notice in Cautions and Notices.
6. Install the frame front bolts (2).
Tighten the bolts to 130 Nm (96 lb ft).
7. Install the frame straps (5) and bolts (3).
Tighten the bolts to 50 Nm (37 lb ft).
8. Install the frame rear bolts (4).
Tighten the bolts to 240 Nm (177 lb ft).
9. Remove the alignment pins from the frame.
10. Install the transaxle mount nuts. Refer toAutomatic Transmission Mount Replacement in Automatic Transaxle - 4T65-E.
11. Install the engine mount nuts. Refer toEngine Mount Replacement - Right in Engine Mechanical - 3.5L.
12. Install the wheel speed sensor wiring harnesses to the lower control arms.
13. Connect the wheel speed sensor electrical connectors.
14. Install the lower ball joints to the steering knuckles. Refer toSteering Knuckle Replacement in Front Suspension.
15. Install the power steering cooler pipe to the frame. Refer toPower Steering Cooler Pipe/Hose Replacement in Power Steering System.
16. Install the front engine splash shield. Refer toSplash Shield Replacement - Engine (See: Body and Frame/Splash Guard/Service and Repair) in
Body Front End.
17. Install the power steering gear to the frame. Refer toPower Steering Gear Replacement in Power Steering System.
18. Install the power steering gear bolts. Refer toPower Steering Gear Replacement in Power Steering System.
19. Install the power steering gear heat shield. Refer toPower Steering Gear Heat Shield Replacement in Power Steering System.
20. Install the propeller shaft, if equipped with AWD. Refer toPropeller Shaft Replacement in Propeller Shaft.
21. Install the catalytic converter pipe, if equipped with AWD. Refer toCatalytic Converter Replacement in Engine Exhaust.
22. Install the stabilizer shaft. Refer toStabilizer Shaft Replacement (FWD) Stabilizer Shaft Replacement (AWD) in Front Suspension.
23. Install both tie rod ends to the steering knuckles. Refer toSteering Knuckle Replacement in Front Suspension.
24. Install the front fender liner . Refer toWheelhouse Liner Replacement - Front (See: Body and Frame/Fender/Front Fender/Front Fender
Liner/Service and Repair) in Exterior Trim.
25. Install the front tires and wheels. Refer toTire and Wheel Removal and Installation in Tires and Wheels.
26. Lower the vehicle.
27. Remove the engine support fixture. Refer toEngine Support Fixture in Engine Mechanical - 3.5L.
28. Inspect the front wheel alignment and adjust the toe angle if necessary. Refer toMeasuring Wheel Alignment in Wheel Alignment.
