Uplander AWD V6-3.5L VIN 8 (2005)
Notice: Refer to Avoid Chipping or Scratching the Coating Notice in Service Precautions.
1. Install the coil spring (2)
2. Use the utility jack in order to raise the lower control arm and load the suspension.
3. Use the J 41820 in order to connect the ball joint to the knuckle.
4. Install the stabilizer link to the lower control arm.
5. Use the utility jack in order to support the lower control arm.
6. Install the ABS electrical connector mounting bracket.
7. Connect the ABS electrical connector.
8. Install the brake caliper mounting bracket.
9. Install the parking brake cable mounting bracket.
10. Install the brake calipers.
11. Install the wheel and tire assemblies.
12. Lower the vehicle.
