Uplander AWD V6-3.5L VIN 8 (2005)
8. Inspect each check valve seat in the spacer plate (370) for excessive peening. Place a ball check valve (372) on each seat and use a flashlight in
order to look for visible light between the valve and the seat.
9. Inspect all components removed from the transaxle. Refer to the Transmission/Transaxle/Transfer Case Unit Repair.
Installation Procedure
Notice: Do NOT use any type of grease to retain parts during the assembly of this unit. Using greases other than the recommended assembly lube
changes the transaxle fluid characteristics. Using greases other than the recommended assembly lube causes undesirable shift conditions and/or
filter clogging. Use TRANSJEL(tm) J 36850 or equivalent during the assembly of this unit.
1. Install the ball check valves (372) into the case cover. Use the J 36850 to retain the ball check valves in their proper locations.
2. Install the gasket and the spacer plate (370).
