Uplander AWD V6-3.5L VIN 8 (2005)
7. Notice: Refer to Fastener Notice in Service Precautions.
Install the extension housing assembly to the J 44755 (2) using M8 x 1.25 bolts (1).
^
Tighten the bolts to 25 Nm (18 ft. lbs.).
8. Install the flange nut (1) onto the driven shaft.
^
Tighten the flange nut to 200 Nm (148 ft. lbs.).
9. Remove the extension housing assembly from the J 44755.
10. Measure the rotating torque of the driven shaft in both directions.
11. When reusing driveshaft bearings, the rotating torque should equal the value recorded during disassembly.
A properly assembled shaft and NEW bearings should have a rotating torque of 1.5 Nm (13 inch lbs.).
12. Reinstall J 44755 to tighten the flange nut as required to achieve the proper rotating torque value. Do NOT loosen the flange nut to achieve the