Uplander AWD V6-3.5L VIN 8 (2005)
Windshield Washer Reservoir: Service and Repair
WASHER SOLVENT CONTAINER REPLACEMENT
REMOVAL PROCEDURE
1. Reposition the underhood electrical center.
2. Remove the right front diagonal brace.
3. Disconnect the electrical connectors from the washer pumps.
4. Disconnect the washer hose connections at the front and rear washer pumps.
5. Contain the washer solvent in a suitable container.
6. Disconnect the 2 front engine wiring harness connections from the wiring harness.
7. Remove the bolts from the fender flange and inner wheelhouse.
8. Lower the washer container into the engine compartment.
9. Carefully pull the forward engine harness over the top of the washer container spout.
10. Remove the washer solvent container (2) from the engine compartment.
11. Transfer the following components:
-
Cap
-
Front washer pump
-
Rear washer pump, if equipped
INSTALLATION PROCEDURE