Uplander AWD V6-3.5L VIN 8 (2005)
Wiper Motor: Service and Repair
Wiper Motor Crank Arm Replacement
WIPER MOTOR CRANK ARM REPLACEMENT
TOOLS REQUIRED
-
J 39232 Wiper Linkage Separator
-
J 39529 Wiper Linkage Installer
REMOVAL PROCEDURE
1. Raise and support the hood.
IMPORTANT: Ensure the wiper system is in the PARK position.
2. Disconnect the wiper motor electrical connector.
3. Lower the wiper motor module from the air plenum. Refer to Wiper Motor Module Replacement.
4. Using the J 39232, separate the wiper transmission link (1) from the wiper motor crank arm.
5. Remove the wiper motor pivot shaft nut (4).
6. Remove the crank arm (5) from the wiper motor pivot shaft.
INSTALLATION PROCEDURE
