Uplander FWD V6-3.5L VIN L (2006)
3. Remove the right and left front fender liner. Refer to Wheelhouse Liner Replacement - Front (See: Fender/Front Fender/Front Fender
Liner/Service and Repair) in Body Front End.
4. Disconnect both daytime running lamps (DRL). Refer to Daytime Running Lamp, Park and Turn Signal Lamp and Bulb Replacement - Front.
5. Use the J 38778 to remove the push-in retainers (2) from the upper front bumper fascia.
6. Loosen the 2 hidden fasteners from the upper rear corners of the front fascia.
7. Remove the front bumper fascia from the vehicle.
8. Remove the DRL lamps from the fascia.
9. Remove the screws securing the energy absorber to the lower fascia.
10. Remove the impact bar energy absorber from the lower fascia.
Installation Procedure
1. Install the DRL lamps to the fascia, connect the wiring as fascia is put on the vehicle.
2. Position the energy absorber to the lower fascia.
3. Install the screws in order to secure the energy absorber to the lower fascia.
