Uplander FWD V6-3.5L VIN L (2006)
Sliding Door Hold-Open Latch: Service and Repair
Door Check Link Replacement - Sliding
Removal Procedure
Important: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door
modules (PSDM) will be interrupted and both PSDs will be inoperative.
1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
2. Open the sliding door half way.
3. Remove the bolt (2) for the sliding door catch (1) with the reinforcement channel (4) from the sliding door lower track (3).
4. Remove the sliding door catch with the reinforcement channel from the sliding door lower track.
Installation Procedure
