Uplander FWD V6-3.5L VIN L (2006)
3. Install the remainder of the sliding door opening weatherstrip.
4. Roll the weatherstrip onto the flange as indicated by directional arrows, beginning at the weatherstrip joint.
5. Ensure that the weatherstrip corners are fully seated.
6. DO NOT stretch the front door opening weatherstrip during the installation.
7. Join the loose end of the front door opening weatherstrip to the seated end.
Important: Removing the tear strip is designed to pull the inner lip of the sliding door opening weatherstrip out over the trim. Spoon the
sliding door opening weatherstrip in order to complete the installation as needed.
Inspect the sliding door opening weatherstrip for creases or wrinkles.
8. Pull the end of the tear strip from the joint along the entire length of the sliding door opening weatherstrip.
Important: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be
operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Acutator Control
Module - Power Sliding Door (PSD) Programming and Setup.
9. If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.
