Uplander FWD V6-3.5L VIN L (2006)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Replacement - Front
Wheel Speed Sensor Replacement - Front
Removal Procedure
Important: The front wheel speed sensors and rings are integral with the hub and bearing assemblies.
If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly. Do not service the harness pigtail individually because the
harness pigtail is part of the sensor.
Remove the hub and bearing assembly.
Installation Procedure
1. Install the hub and bearing assembly to the vehicle.
2. Lower the vehicle.
3. Turn the ignition switch to the RUN position with the engine OFF.
4. Perform diagnostic system check. Refer to Diagnostic System Check - Vehicle. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures
