Uplander FWD V6-3.5L VIN L (2006)
1. Install the brake caliper bracket (1).
2. Notice: Refer to Fastener Notice in Service Precautions.
Important: To ensure that the proper clamp load will be present when installed, it is imperative that the threads on the caliper bracket bolts, as
well as the mounting holes in the knuckle, be cleaned of all debris and inspected before proceeding with installation.
Clean and visually inspect the threads of the caliper bracket bolts (2) and the mounting holes in the knuckle.
Apply GM P/N 12345493 or equivalent to the threads of the brake caliper bracket bolts (2).
Install the brake caliper bracket bolts.
^
Tighten the bolts to 185 Nm (137 ft. lbs.).
3. Install the brake pad retainers (4) to the brake caliper bracket.
4. Apply a thin coat of high temperature silicone brake lubricant to the brake pad retainers (4) where the brake pads contact the brake pad retainers.
5. Lubricate the brake caliper bolt boots with high temperature silicone brake lubricant.
6. Install the brake caliper bolt boots to the brake caliper bracket.
7. Install the brake pads to the brake caliper bracket.
8. Install the brake caliper.
