Uplander FWD V6-3.5L VIN L (2006)
6. Remove the BPMV mounting bracket nuts (2) from the inner wheel housing mount surface of the strut tower.
7. Reinstall the top nut upside down on the top stud.
8. Lightly tap on the bottom of the nut until the stud has loosened up.
9. Remove the BPMV mounting bracket and EBCM assembly from the vehicle.
10. Notice: When removing the brake pressure modulator valve, protect the vehicle exterior from possible brake fluid spillage. Brake fluid can cause
damage to painted surfaces.
Remove the bolt that connects the BPMV to the mounting bracket.
11. Lift the BPMV off the mounting bracket studs.
12. Remove EBCM if replacing the BPMV only.
Installation Procedure
1. Install EBCM onto the BPMV if replacing the BPMV only.
