Uplander FWD V6-3.5L VIN L (2006)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Replacement - Rear
Wheel Speed Sensor Replacement - Rear
Removal Procedure
Important: The rear wheel speed sensors and rings are integral with the hub and bearing assemblies.
If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly.
Remove the hub and bearing assembly.
Installation Procedure
1. Install the hub and bearing assembly to the vehicle.
2. Turn the ignition switch to the ON position, with the engine OFF.
3. Perform the diagnostic system check. Refer to Diagnostic System Check - Vehicle. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures
