Uplander FWD V6-3.5L VIN L (2006)
1. Install the engine mount to the engine mount bracket.
2. Install the engine mount bracket with the engine mount to the oil pan.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the engine mount bracket-to-oil pan bolts.
^
Tighten the bolts to 58 Nm (43 ft. lbs.).
4. Use the utility stand in order to lower the engine.
5. Install the engine mount lower nuts.
^
Tighten the nuts to 47 Nm (35 ft. lbs.).
6. Install the right engine splash shield.
7. Install the right front wheel and tire.
8. Connect the catalytic converter pipe to the engine exhaust manifold.
10. Install the engine mount struts.
11. Install the throttle body air inlet duct.
Engine Mount Strut Bracket Replacement - Left
Engine Mount Strut Bracket Replacement - Left
Removal Procedure
