Uplander FWD V6-3.5L VIN L (2006)
2. Turn OFF the ignition.
3. Remove the key from the ignition switch.
4. Open the hood and locate the underhood fuse center.
5. Lift the cover for the underhood fuse center.
6. Locate and remove the air bag fuse from the underhood fuse center.
IMPORTANT: With the Air Bag Fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation, and does not
indicate an SIR system malfunction.
7. Remove the connector position assurance (CPA) (3) from the RR side impact module yellow connector (3) which is located under the driver seat.
8. Disconnect the vehicle harness connector (4) from the RR side impact module connector (1).
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. Connect the vehicle harness connector (4) to the RR side impact module yellow connector (1).
3. Install the CPA to the RR side impact module connector (1).
4. Install the Air Bag Fuse.
5. Install the cover for the underhood fuse center.
6. Use caution while reaching in and turning the ignition switch to the ON position.The AIR BAG indicator will flash, then turn OFF.
7. Perform the Diagnostic System Check - Vehicle, if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures
