Uplander FWD V6-3.5L VIN L (2006)
1. Position the new fuel sender assembly seal (2) on the fuel tank.
CAUTION: In order to reduce the risk of fire and personal injury that may result from a fuel leak, always replace the fuel sender gasket
when reinstalling the fuel sender assembly.
2. Install the fuel sender assembly (7) into the fuel tank.
IMPORTANT: Care should be taken not to fold over or twist the fuel pump strainer when installing the fuel sender assembly, as this will restrict fuel
flow. Also, ensure that the fuel pump strainer does not block full travel of float arm.
3. Use the J 45722 in order to install the fuel sender lock ring. Turn the fuel sender lock ring in a clockwise direction.
IMPORTANT: Always replace the fuel sender seal when installing the fuel sender assembly. Replace the lock ring if necessary. Do not apply any
type of lubrication in the seal groove.
Ensure the lock ring is installed with the correct side facing upward. A correctly installed lock ring will only turn in a clockwise direction.
4. Connect the fuel supply pipe quick-connect fitting (3) at the fuel sender assembly.
5. Connect the EVAP quick-connect fittings (5, 6) at the fuel sender assembly.
6. Connect the fuel sender electrical connections (4)
7. Install the fuel tank.
