Uplander FWD V6-3.5L VIN L (2006)
8. Remove the driver/left lower center pillar trim cover.
9. Remove the connector position assurance (CPA) from the driver/left seat belt retractor pretensioner connector.
10. Remove the vehicle wiring harness connector from the left seat belt retractor pretensioner.
11. Remove the driver/left instrument panel (I/P) insulator panel.
12. Remove the CPA from the steering wheel module coil yellow connector (1), located at the base of the steering column.
13. Disconnect the steering wheel module coil connector (1).
14. Remove the CPA (3) from the LF/driver side impact module yellow connector (3), which is located under the driver seat.
15. Disconnect the vehicle harness connector (4) from the LF side impact module connector (1).
16. Remove the CPA (3) from the LR side impact module yellow connector (3), which is located under the LR seat.
17. Disconnect the vehicle harness connector (4) from the LR side impact module connector (1).
