Uplander FWD V6-3.5L VIN L (2006)
1. Connect the wheel speed sensor electrical connector.
2. Install the wheel bearing/hub.
3. Caution:
These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after
they become loose or are removed may cause loss of vehicle control and personal injury.
Notice:
Refer to Fastener Notice.
Install the NEW wheel bearing/hub bolts.
Tighten the NEW wheel bearing/hub bolts to 80 Nm (59 ft. lbs.).
4. Install the brake caliper.
5. Install the tire and wheel.
6. Lower the vehicle.
