Uplander FWD V6-3.5L VIN L (2006)
8. Use the hook tool to pull the connector (1) upward in order to secure the connectors into the base.
IMPORTANT: Using a hook-type tool, as shown, re-stage all 3 lower harness connectors into the lower base prior to installing the new underhood
accessory wiring junction block assembly.
INSTALLATION PROCEDURE
1. Verify that all 3 connectors (1) are secured to the base by applying light downward pressure to each connector and verifying the tabs are locked (2)
on each side of the connector.
2. Position the new underhood accessory wiring junction block assembly over the top of the base and align the locator pins to the underhood
accessory wiring junction block assembly base.
3. Once aligned, apply downward pressure to the new underhood accessory wiring junction block assembly in order to secure the top half to the base.
