Uplander FWD V6-3.5L VIN L (2006)
CAUTION: Refer to Relieving Fuel Pressure Caution in Service Precautions.
6. Use a clean shop towel in order to wipe off the male pipe end.
7. Inspect both ends of the fitting for dirt and burrs. Clean or replace the components as required.
INSTALLATION PROCEDURE
1. Apply a few drops of clean engine oil to the male pipe end.
CAUTION: Refer to Fuel Pipe Fitting Caution in Service Precautions.
2. Push both sides of the fitting together in order to snap the retaining tabs into place.
3. Once installed, pull on both sides of the fitting in order to make sure the connection is secure.
4. Install the retainer to the quick-connect fitting.
