Uplander FWD V6-3.5L VIN L (2006)
2. Connect the vehicle wiring harness connector to the left seat belt retractor pretensioner.
3. Install the CPA to the left seat belt retractor pretensioner connector.
4. Connect the left SIS wiring harness connector (2) to the left SIS (1).
5. Install the CPA (3) to the SIS connector (1).
6. Position the SIS (1) back inside the center pillar and slide back into place and tighten the SIS fasteners.
7. Install the left lower center pillar trim cover.
8. Install the Air Bag Fuse.
9. Install the cover for the underhood fuse center.
10. Use caution while reaching in and turning the ignition switch to the ON position.The AIR BAG indicator will flash, then turn OFF.
11. Perform the Diagnostic System Check - Vehicle, if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures
