chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Deployment Inside Vehicle - Vehicle Scrapping Procedure|Page 12419 > < Deployment Inside Vehicle - Vehicle Scrapping Procedure|Page 12417
Page 3
background image

17. Inspect that the 3 wire connection is secure.

18. Bend flat the twisted connection.

19. Secure and insulate the 3-wire connection to deployment harness using electrical tape.

20. Connect the deployment harness to the steering wheel module in-line connector.

21. Route the deployment harness out of the driver side of the vehicle.

22. Disconnect the driver side impact module yellow connector (1) from the vehicle wiring harness (4) located under the driver seat.

Deployment Inside Vehicle - Vehicle Scrapping Procedure|Page 12419 > < Deployment Inside Vehicle - Vehicle Scrapping Procedure|Page 12417