Uplander FWD V6-3.5L VIN L (2006)
9. If you have an I/P inflator module, refer to the following instructions:
-
Place the J 39401-B (2) in the center of the cleared area.
-
Fill the deployment fixture with water or sand.
-
Using the proper nuts and bolts, mount the I/P module (1) to the deployment fixture (2), with the vinyl trim facing up.
-
Tighten all fasteners that hold the I/P module (1) to the deployment fixture (2).
10. If you have a side impact module, refer to the following instructions:
-
Place the J 39401-B (3) in the center of the cleared area.
-
Fill the deployment fixture with water or sand.
-
Using the proper nuts and mount the side impact module (1) to the deployment fixture (3), with the vinyl trim facing up.
-
Adjust and secure the fixture arms (4) to the deployment fixture (3).
-
Tighten all fasteners that hold the side impact module (1) to the deployment fixture (3).
11. Inspect the J 38826 and the appropriate pigtail adapter for damage. Replace as needed.
12. Short the 2 SIR deployment harness leads (1) together using one banana plug seated into the other.
13. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
IMPORTANT: Refer to Tools Required list for the correct adapter.
14. Extend the SIR deployment harness and adapter to full length from the deployment fixture.
15. Connect the inflator module to the adapter (2) on the SIR deployment harness (1).
IMPORTANT: On the steering wheel dual stage inflator module both connectors must be attached to the deployment harness adapter. This will
ensure that both stage 1 and stage 2 of the deployment loops are energized, regardless of the deployment state.
