Uplander FWD V6-3.5L VIN L (2006)
3. Install the CPA (2) to the I/P module connector (1).
4. Install the right I/P insulator panel.
5. Install the Air Bag Fuse.
6. Install the cover for the underhood fuse center.
7. Use caution while reaching in and turning the ignition switch to the ON position.The AIR BAG indicator will flash, then turn OFF.
8. Perform the Diagnostic System Check - Vehicle, if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures
SIR Disabling and Enabling Zone 6
SIR DISABLING AND ENABLING ZONE 6
DISABLING PROCEDURE
IMPORTANT: Refer to SIR Service Precautions.
1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
2. Turn OFF the ignition.
3. Remove the key from the ignition switch.
4. Open the hood and locate the underhood fuse center.
5. Lift the cover for the underhood fuse center.
6. Locate and remove the air bag fuse from the underhood fuse center.
IMPORTANT: With the Air Bag Fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation, and does not
indicate an SIR system malfunction.
7. Remove the passenger/right lower center pillar trim cover.
8. Loosen the right side impact sensor (SIS) fasteners, then slide the right SIS (1) up and remove from the center pillar.
9. Remove the connector position assurance (CPA) (3) from the SIS connector (2).
10. Disconnect the SIS wiring harness connector (2) from the SIS (1).
11. Remove the CPA from the passenger/right seat belt retractor pretensioner connector.
12. Remove the vehicle wiring harness connector from the right seat belt retractor pretensioner.
ENABLING PROCEDURE
1. Remove the key from the ignition.