Uplander FWD V6-3.5L VIN L (2006)
4. Place the seat belt guide loop to the guide adjuster bracket.
5. Install the nut to the seat belt guide loop.
Tighten the nut to 42 N.m (31 lb ft).
6. Install the seat belt guide loop cover.
7. Place the seat belt anchor plate to the seat rear outboard stud.
8. Install the front bucket seat.
9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9.
Pretensioner Handling and Scrapping
PRETENSIONER HANDLING AND SCRAPPING
TOOLS REQUIRED
-
J 38826 SIR Deployment Harness
-
J 38826-25 for Seat Belt Pretensioner Module Adapter
-
J 39401-B SIR Deployment Fixture
CAUTION: When you are carrying an undeployed seat belt pretensioner:
-
Do not carry the seat belt pretensioner by the wires or connector on the pretensioner.
-
Do not touch the seat belt pretensioner in the area of the cable (1).
-
Do not cover the tube opening with your hand.
-
Keep the open end of the tube pointed away from you. Do not point the open end of the tube at another person.
-
When the pretensioner deploys the cable retracts. This shortens the pretensioner between the buckle and the mounting bolt. Grasp the
pretensioner by the piston tube (2).
Disregarding these precautions may result in personal injury or unnecessary SIR system repairs.
Scrapping Procedure
During the course of a vehicle's useful life, certain situations may arise which will necessitate the disposal of a live (undeployed) pretensioner. The
following information covers the proper procedures for the disposing of a live (undeployed) pretensioner. Deploy the pretensioner before disposal. Do
not dispose of a live (undeployed) pretensioner through normal disposal channels until the pretensioner has been deployed. The following information
covers the proper procedures for the disposing of a live (undeployed) pretensioner.
-
After replacement of a pretensioner under warranty-The pretensioner may need to be returned undeployed to the original manufacturer of
