Uplander FWD V6-3.5L VIN L (2006)
13. Connect the I/P module yellow connector (1).
14. Install the CPA (2) to the I/P module connector (1).
15. Install the right I/P insulator panel.
16. Connect the vehicle wiring harness connector to the right seat belt retractor pretensioner.
17. Install the CPA to the right seat belt retractor pretensioner connector.
18. Install the right lower center pillar trim cover.
19. Connect the vehicle harness connector (4) to the RR side impact module yellow connector (1).
20. Install the CPA to the RR side impact module connector (1).
21. Connect the vehicle harness connector (4) to the RF side impact module yellow connector (1).
22. Install the CPA to the RF side impact module connector (1).
23. Install the Air Bag Fuse.
24. Install the cover for the underhood fuse center.
25. Use caution while reaching in and turning the ignition switch to the ON position. The AIR BAG indicator will flash, then turn OFF.
