Uplander FWD V6-3.5L VIN L (2006)
2. Install the outer tie rod (2) to the steering knuckle (1).
3. Important:
This is a prevailing torque type fastener. You may reuse this fastener ONLY under the following conditions:
-
The fastener and its counterpart are clean and free from rust.
-
The fastener develops 2 Nm (18 inch lbs.) of torque/drag against its counterpart prior to the fastener seating.
If the fastener does not meet these criteria, REPLACE the fastener.
Notice:
Refer to Fastener Notice in Service Precautions.
Important:
Ensure that 2.5-4.5 tie rod end threads are visible beyond the tie rod nut nylon.
Install the tie rod ball stud nut.
Tighten the tie rod ball stud nut to 30 Nm (22 ft. lbs.) + 120 degrees.
