Uplander FWD V6-3.5L VIN L (2006)
the frame.
Notice: Refer to Fastener Notice in Cautions and Notices.
6. Install the frame front bolts (2).
Tighten the bolts to 130 N.m (96 lb ft).
7. Install the frame straps (5) and bolts (3).
Tighten the bolts to 50 N.m (37 lb ft).
8. Install the frame rear bolts (4).
Tighten the bolts to 240 N.m (177 lb ft).
9. Remove the alignment pins from the frame.
10. Install the transaxle mount nuts. Refer to Automatic Transmission Mount Replacement.
11. Install the engine mount nuts. Refer to Engine Mount Replacement - Right.
12. Install the wheel speed sensor wiring harnesses to the lower control arms.
13. Connect the wheel speed sensor electrical connectors.
14. Install the lower ball joints to the steering knuckles. Refer to Steering Knuckle Replacement.
15. Install the power steering cooler pipe to the frame. Refer to Power Steering Cooler Pipe/Hose Replacement.
16. Install the front engine splash shield. Refer to Splash Shield Replacement - Engine (See: Body and Frame/Splash Guard/Service and Repair) in
Body Front End.
17. Install the power steering gear to the frame. Refer to Power Steering Gear Replacement.
18. Install the power steering gear bolts. Refer to Power Steering Gear Replacement.
19. Install the power steering gear heat shield. Refer to Power Steering Gear Heat Shield Replacement.
20. Install the propeller shaft, if equipped with AWD. Refer to Propeller Shaft Replacement.
21. Install the catalytic converter pipe, if equipped with AWD. Refer to PSD SIE TITLE Error: SIE linked to empty Cell ID 37817 in Engine Exhaust.
22. Install the stabilizer shaft. Refer to Stabilizer Shaft Replacement (FWD) and Stabilizer Shaft Replacement (AWD).
23. Install both tie rod ends to the steering knuckles. Refer to Steering Knuckle Replacement.
24. Install the front fender liner . Refer to Wheelhouse Liner Replacement - Front (See: Body and Frame/Fender/Front Fender/Front Fender
Liner/Service and Repair) in Exterior Trim.
25. Install the front tires and wheels. Refer to Tire and Wheel Removal and Installation.
26. Lower the vehicle.
27. Remove the engine support fixture. Refer to Engine Support Fixture.
28. Inspect the front wheel alignment and adjust the toe angle if necessary. Refer to Measuring Wheel Alignment.
