Uplander FWD V6-3.5L VIN L (2006)
Saturn Relay Shown, others Similar
After the wheel covers are completely dry, each wheel cover should be wiped with isopropyl alcohol on a clean, lint-free, non-abrasive cloth and apply
Adhesion Promoter, P/N 12378462, or equivalent, at the insulator locations. Insulator location is at the center of each spoke in the groove. Place two
insulators at the location where a divider prevents one from going in the center. Refer to the illustrations above.
Peel the red non-stick backing off of the insulator.
Carefully place the insulator onto the wheel cover so that the area under the lip is resting against the corner of the inside edge of the wheel cover lip. This
should place the insulator flush with the outside edge of the wheel cover.
Press down firmly on the insulator to ensure that the adhesive is bonding to the wheel cover.
Place another insulator in the next location by repeating Steps 5 through 7. There should be an insulator at each spoke location with two being placed at
