Uplander FWD V6-3.5L VIN L (2006)
17. Remove the inner race (1) from the cage (2) by rotating the inner race (1) upward.
18. Clean the following items thoroughly with cleaning solvent. Remove all traces of old grease and any contaminates.
^
The inner and outer race assemblies
^
The CV joint cage
^
The chrome alloy balls
19. Dry all the parts.
20. Check the CV joint assembly for the following items:
^
Unusual wear
^
Cracks
^
Damage
21. Replace any damaged parts.
22. Clean the halfshaft bar. Use a wire brush to remove any rust in the seal mounting area (grooves).
Assembly Procedure
1. Install the new swage ring or eared clamp (2) on the neck of the outboard seal (1). Do not swage or crimp.
2. Slide the outboard seal (1) onto the halfshaft bar and position the neck of the outboard seal (1) in the seal groove on the halfshaft bar. The largest
groove below the sight groove on the halfshaft bar is the seal groove (3).
