Uplander FWD V6-3.5L VIN L (2006)
11. Place approximately half of the grease from the service kit in the halfshaft inboard seal. Use the remainder of the grease to repack the housing.
12. Important:
Ensure the trilobal tripot bushing (3) is flush with the face of the housing (1).
Install the trilobal tripot bushing (3) to housing (1).
13. Position the larger new seal retaining clamp (2) on the halfshaft inboard seal.
14. Slide the housing (1) over the tripot joint spider assembly on the halfshaft bar.
15. Slide the large diameter of the halfshaft inboard seal (2), with larger clamp (3) in place, over the outside of the trilobal tripot bushing and locate
the lip of the seal in the groove.
16. Important:
