Uplander FWD V6-3.5L VIN L (2006)
3. Important:
For eared clamp installation, proceed to step 6.
For swage ring installation use J 41048 in the following way:
1. Position the outboard end of the halfshaft assembly (1) in J 41048.
2. Align the swage ring.
3. Place the top half of J 41048 on the lower half of J 41048.
4. Notice:
Refer to Fastener Notice in Service Precautions.
Important:
Align the following items during this procedure:
^
The outboard seal (1)
^
The halfshaft bar
^
The swage ring
Insert the bolts (2) and tighten by hand until snug.
Tighten each bolt 180 degrees at a time using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
