Uplander FWD V6-3.5L VIN L (2006)
19. Important:
The outboard seal (1) must not be dimpled, stretched or out of shape in any way. If the outboard seal (1) is not shaped correctly, equalize the
pressure in the outboard seal (1) and shape the seal properly by hand.
Slide large diameter of the outboard seal (1) with the large seal retaining clamp (2) in place over the outside of the CV joint outer race (3) and
locate the seal lip in the groove on the CV joint outer race.
20. Crimp the seal retaining clamp (1) using J 35910.
Crimp the clamp (1) to 174 Nm (130 ft. lbs.).
21. Check the gap dimension on the clamp ear. Continue tightening until the gap dimension is reached. Dimension a= 1.9 mm (5/64 inch).
