V 20 P/U 4WD V6-262 4.3L (1987)
*
Grind a V-groove along entire length of crack.
*
Weld the V-groove completely, filling the entire length past the hole(s) by 1/4".
*
Grind smooth to allow tight reinforcement fit.
Right-Hand Reinforcement Bracket Installation
CAUTION:
PROPER EYE PROTECTION IS REQUIRED AT ALL TIMES WHEN PERFORMING THE FOLLOWING PROCEDURES.
1.
Disconnect batteries.
Figure No. 1 (RH)
2.
Remove retainer clips (2) and (3) from fuel feed line (1) at right-hand frame rail. Refer to figure 1 RH.
Figure No. 2 (RH)
3.
Remove existing nuts (3), washers (2), and bolts (8). DISCARD. Refer to Figure 2 RH.
4.
Remove existing nut (4), washer (5), and bolt (9). DISCARD. Refer to Figure 2 RH.