Venture AWD V6-3.4L VIN E (2004)
10. Disconnect the master cylinder brake pipes from the BPMV.
11. Loosen the brake pipes but do not remove the brake pipes from the master cylinder.
12. Swing the 2 master cylinder brake pipes out of the way only after covering the open pipes to avoid dripping or being contaminated.
13. Remove the 3 BPMV mounting bracket nuts (2) from the inner wheel housing mount surface of the strut tower.
14. Reinstall the top nut upside down on the top stud.
15. Lightly tap on the bottom of the nut until the stud has loosened up.
16. Disconnect the ground strap between the EBCM assembly and the chassis.
17. Remove the BPMV mounting bracket and EBCM assembly from the vehicle.
Notice: When removing the brake pressure modulator valve, protect the vehicle exterior from possible brake fluid spillage. Brake fluid can cause
damage to painted surfaces.
18. Remove the two bolts (1) that connect the BPMV to the mounting bracket (2).
