Venture AWD V6-3.4L VIN E (2004)
1. Install the required bulbs to the sockets, if removed.
2. Install the tail lamp circuit board to the tail lamp.
3. Connect the electrical connector to the tail lamp.
4. Align the tail lamp locking guide pins to the body.
5. Press the tail lamp into the locking guide pin holes.
6. Install the screws to the tail lamp.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 10 N.m (89 lb in).
7. Close the liftgate.
