Venture AWD V6-3.4L VIN E (2004)
an SIR system malfunction.
4. Remove the SIR fuse from the fuse block.
5. Remove the connector position assurance (CPA) from the side impact module - LF yellow 2-way connector (4) located under the driver seat.
6. Disconnect the side impact module - LF yellow 2-way connector (4).
7. Remove the CPA from the seat belt pretensioner - LF yellow 2-way connector (3) located under the driver seat.
8. Disconnect the seat belt pretensioner - LF yellow 2-way connector (3).
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. Connect the seat belt pretensioner - LF yellow 2-way connector (3) located under the driver seat.
3. Install the CPA to the seat belt pretensioner - LF yellow 2-way connector (3).
4. Connect the side impact module - LF yellow 2-way connector (4) located under the driver seat.
5. Install the CPA to the side impact module - LF yellow 2-way connector (4).
6. Install the SIR fuse into the fuse block.
7. Staying well away from all air bags and pretensioners, turn ON the ignition, with the engine OFF.
7.1.
The AIR BAG indicator will flash 7 times.
7.2.
The AIR BAG indicator will then turn OFF.
8. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
SIR Disabling and Enabling Zone 9
SIR DISABLING AND ENABLING ZONE 9
DISABLING PROCEDURE
