Venture AWD V6-3.4L VIN E (2004)
5. Remove the accelerator control cable bracket.
6. Disconnect the throttle body coolant bypass hoses.
7. Disconnect the heater pipe nut at the throttle body.
8. Remove the nuts and bolts holding the throttle body to the intake manifold.
9. Remove the throttle body assembly.
10. Remove the old gasket.
INSTALLATION PROCEDURE
NOTE: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the
gasket surfaces and throttle body assembly may result. Use care in cleaning the gasket surfaces on the intake manifold and the throttle body assembly,
as sharp tools may damage the gasket surfaces.
1. Clean the gasket surface on the intake manifold and the throttle body assembly.
2. Install a new gasket, if necessary.
