Venture AWD V6-3.4L VIN E (2004)
Ignition Cable: Service and Repair
SPARK PLUG WIRE REPLACEMENT
REMOVAL PROCEDURE
1. Turn OFF the ignition.
NOTE: Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug wire or
the wire could be damaged.
2. Remove the spark plug wires (2, 4, 6) from the front bank spark plugs.
3. Remove the spark plug wires from the retaining clips.
4. Rotate the engine forward. Refer to Rotating the Engine for Service Access in Engine.
5. Remove the spark plug wires (1, 3, 5) from the rear bank spark plugs.
6. Remove the spark plug wires from the retaining clips.
