Venture AWD V6-3.4L VIN E (2004)
5. Connect the steering wheel module coil yellow 4-way connector (2) located at the base of the steering column.
6. Install the CPA (3) to the steering wheel module coil yellow 4-way connector (2).
7. Install the left instrument panel insulator panel.
8. Connect the seat belt pretensioner - LF yellow 2-way connector (3) located under the driver seat.
9. Install the CPA to the seat belt pretensioner - LF yellow 2-way connector (3).
10. Connect the side impact module - LF yellow 2-way connector (4) located under the driver seat.
11. Install the CPA to the side impact module - LF yellow 2-way connector (4).
12. Connect the seat belt pretensioner - RF yellow 2-way connector (3) located under the front passenger seat.
13. Install the CPA to the seat belt pretensioner - RF yellow 2-way connector (3).
14. Connect the side impact module - RF yellow 2-way connector (4) located under the front passenger seat.
15. Install the CPA to the side impact module - RF yellow 2-way connector (4).
16. Install the SIR fuse into the fuse block.
17. Staying well away from all air bags and pretensioners, turn ON the ignition, with the engine OFF.
17.1. The AIR BAG indicator will flash 7 times.
17.2. The AIR BAG indicator will then turn OFF.
18. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
