Venture AWD V6-3.4L VIN E (2004)
2. Connect the front end sensor connectors (2) to both front end sensors.
3. Install the CPAs to both front end sensor connectors (2).
4. Install the SIR fuse into the fuse block.
5. Staying well away from all air bags and pretensioners, turn ON the ignition, with the engine OFF.
5.1.
The AIR BAG indicator will flash 7 times.
5.2.
The AIR BAG indicator will then turn OFF.
6. Perform the Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.
SIR Disabling and Enabling Zone 2
SIR DISABLING AND ENABLING ZONE 2
DISABLING PROCEDURE
IMPORTANT: Refer to SIR Service Precautions before disabling the SIR system.
1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
2. Turn OFF the ignition.
3. Remove the key from the ignition.
IMPORTANT: With the SIR fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation and does not indicate
an SIR system malfunction.
4. Remove the SIR fuse from the fuse block.
5. Remove the seat belt retractor trim cover.
6. Remove the connector position assurance (CPA) (3) from the SIS-LF yellow 2-way connector (2) located near the bottom of the left side B-Pillar.
7. Disconnect the SIS-LF yellow 2-way connector (2) from the SIS-LF (1).
ENABLING PROCEDURE
1. Remove the key from the ignition.
