Venture AWD V6-3.4L VIN E (2004)
10. Raise the rear of the seat in order to remove the seat belt anchor bracket (5) from the seat stud (4).
11. Remove the push-on the retainer (6) from the seat stud (4).
12. Remove the retractor side belt (1) from the vehicle.
INSTALLATION PROCEDURE
1. Install the retractor side belt (1) to the vehicle.
2. Install the seat belt anchor bracket (5) to the seat stud (4).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the nuts securing the seat belt (1) lower anchor bracket to the floor.
Tighten
Tighten the anchor nuts to 40 N.m (30 lb ft).
