Venture AWD V6-3.4L VIN E (2004)
3. If the vehicle is equipped with automatic level control, disconnect the air tube connector from the shock absorber.
4. Remove the shock absorber upper bolt (1) and nut (2).
5. Remove the shock absorber lower nut (3).
6. Remove the shock absorber.
Installation Procedure
1. Install the shock absorber.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the shock absorber upper bolt (1) and the shock absorber nuts (2 and 3).
^
Tighten the shock absorber nuts (2 and 3) to 85 Nm (63 lb ft).
3. If the vehicle is equipped with automatic level control, install the air tube connector to the shock absorber.
4. Remove the utility stand.
5. Lower the vehicle.
Shock Absorber Disposal
Shock Absorber Disposal
Caution: Gas charged shock absorbers contain high pressure gas. Do not remove the snap ring from inside the top of the tube. If the snap
ring is removed, the contents of the shock absorber will come out with extreme force which may result in personal injury.
Caution: To prevent personal injury, wear safety glasses when centerpunching and drilling the shock absorber. Use care not to puncture the
shock absorber tube with the centerpunch.
