Venture AWD V6-3.4L VIN E (2004)
Notice: Refer to Fastener Notice in Service Precautions.
4. Align the following items:
^
The halfshaft inboard seal (1)
^
The halfshaft bar
^
The swage ring (2)
^
Tighten each bolt of J 41048, 180 degrees at a time using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
5. Install the spacer ring (2) into the groove of the halfshaft bar using J 8059.
6. Slide the tripot joint spider assembly (4) toward the spacer ring (1) as far as it will go on the halfshaft bar.
7. Install the spacer ring (2) into the groove of the halfshaft bar J 8059.
