Volt L4-1.4L Elect (2011)
2. Drill 7 mm (17/64 in) holes (1) for the structural rivets as noted from the original spot weld locations.
3. Apply GM Super Lube or equivalent to drilled locations for corrosion protection.
4. Install structural rivets (1) - GM part number 11610245 or equivalent.
Caution: Refer to Fastener Caution .
Note: Use only the original front bumper impact bar bolts. Replace bolts if damaged.
5. Install the 8 front bumper impact bar bolts (1) and tighten to 110 Nm (81 lb ft).
6. Install all related panels and components.
7. Enable the high voltage system. Refer to High Voltage Enabling .
8. Enable the SIR system. Refer to SIR Disabling and Enabling .
MIG Welding Method
