Volt L4-1.4L Elect (2011)
12. Install the wheel speed sensor wiring harness (2) to the frame on both sides.
Install the wiring harness retainers (3) to the frame and the lower control arm.
13. Install the heater water auxiliary pump and support to the frame. Refer to Heater Water Auxiliary Pump Replacement .
14. Install the heater inlet and outlet pipe fasteners to the frame. Refer to Heater Inlet And Outlet Pipe Replacement .
15. Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
16. Install the catalytic converter. Refer to Catalytic Converter Replacement .
17. Install the front wheelhouse liners. Refer to Front Wheelhouse Rear Liner Replacement (See: Fender/Front Fender/Front Fender Liner/Service
and Repair/Front Wheelhouse Rear Liner Replacement).
18. Lower the vehicle.
19. Remove the support of the radiator and condenser.
20. Install the lower steering intermediate shaft. Refer to Intermediate Steering Shaft Replacement .
21. Remove the engine support fixture from the vehicle.
22. Install the front bumper fascia. Refer to Front Bumper Fascia Removal and Installation (See: Bumper/Front Bumper/Front Bumper Cover /
Fascia/Service and Repair/Front Bumper Fascia Removal and Installation).
23. Check the wheel alignment. Refer to Wheel Alignment Measurement .
24. Enable the high voltage system. Refer to High Voltage Enabling .
25. Connect the negative battery cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .
