300 V6-3.5L (2008)
Front Bumper Cover / Fascia: Service and Repair
Front Fascia - Installation
INSTALLATION
1. If removed, install the push-pin retainer (2) and a new nut insert (1) into each front fender.
NOTE: 300 Shown. Magnum and SRT8 similar.
2. If removed on SRT8 models, install the lower fascia onto the front fascia assembly (4) using new metal retaining clips.
3. If equipped and removed, install the fog lamps onto the front fascia assembly See: Lighting and Horns/Fog/Driving Lamp/Service and Repair/Fog
Lamp - Installation.
4. Position the front fascia assembly to the vehicle and connect each fog lamp wire harness connector (3), if equipped.
5. If equipped, connect the headlamp washer system hose to washer reservoir.See: Wiper and Washer Systems/Headlamp Washer Spray
Nozzle/Service and Repair/Headlamp Washer - Installation
6. On all three SRT8 models, connect the Tire Pressure Monitoring connector.See: Instrument Panel, Gauges and Warning Indicators/Tire
Monitoring System/Tire Pressure Monitor Receiver / Transponder/Service and Repair/TPM Transponder - Removal
7. Engage the push-pin retainer (6) into the slot in each side of the front fascia assembly by pushing the fascia rearward.
8. Install the push-pin retainers (2) (four-sedan, six-wagon, eight Charger) that secure the front fascia assembly to the upper radiator support.
9. Raise and support the vehicle.
10. Install the screw (5) that secures the front fascia assembly to the nut insert (1) in each front fender. Tighten the screws securely.
11. Position belly pan to front of vehicle. Install and tighten screws.
