300 V6-3.5L (2008)
6. Pull the trim panel (2) away from the inside of the door far enough to disengage the locator pins near the top of the panel from the door and the
steel clip fastener. Then lift the rear of the panel upward far enough to disengage the interior door latch lock link and knob (1) from the clearance
hole at the upper rear corner of the panel.
7. Reach between the top of the trim panel (3) and the inside of the door shell to unsnap the plastic clip that secures the end of the interior door
handle latch release link (1) to the handle lever (2) and disengage the link from the handle.
8. Pull the trim panel away from the inside of the door shell far enough to access and disconnect the door wire harness connector (5) from the power
window switch (4).
9. Remove the trim panel from the inside of the door.
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. See: Starting and
Charging/Battery/Service and Repair/Procedures/Battery Reconnection.
Installation
INSTALLATION
